Post by hexixi on Jan 23, 2016 12:04:12 GMT 1
Step 1 — Remove Back Cover.
Make sure before you begin working on your device, that the device is not charging.
Once you have access to the phone, there is a small indent on the bottom left side. Use your fingernail or a plastic opening tool to pry from here and pull off the back casing.
Step 2 — Remove the Battery.
Once you have properly removed the outer casing, the back should look as so.
To remove the battery, pull up from the red mark using your finger. The battery should come up at an angle, and easily be able to be removed.
Once the battery is removed you may safely proceed to the next step.
Step 3 — Screw Removal
Make sure you remove the battery first. You will see that there are 14 screws on the back of the inner case. Use the Phillips head screwdriver to remove each of the screws, make sure to put the screws in a safe place where they will not get lost
FROM:HCQS.CC
Step 4 — Remove Cover
Once you have removed all the screws, you can begin removing the inside cover.
Insert the opening tool using a sliding motion into one of the corners and move it along the edges of the inside cover. This will loosen the edges and the inside cover will pry apart from the shell.
Step 5 — Completion
The inner cover is now removed, you now have access to the many parts on the inside of the phone.
Step 6 — Remove the Ribbon Cable
Using a plastic opening tool, pry the connection between the cable and the phone. With even pressure the cable should disconnect from the logic board easily.
Step 7 — Remove the Camera
After removing the the Ribbon Cable, the Rear-Facing Camera should be able to be removed easily with your fingers.